Hand made one of these for my personal car and had a ton of interest in them, so I made a template and now have them laser cut. It's saved my apron from total annihilation on more than one occasion.
These fit any type I, BJ or LP.
Only hangs down 3/16" and will help you skip over obstacles, landmines, roadkill, curbs, jumps, bumps and lumps!
These bolt to your front axle beam, with the bottom two bolts. No longer bolts needed.
No modifications required but I do suggest cranking up or removing the lower vertical adjuster bolt.
This will provide a little armor for your panhead and in most cases, saves your apron and wheel well from a bit of damage too.
This will fit any type I with a front beam, 38-77.
*Please specify Linkpin or Balljoint when ordering as I do bend them a bit differently for each, for the best fit.
3/16 plate, Hand bent by me and fitted to a beam before shipment.
$45 picked up or $60 shipped. Anywhere in the continental US.
* These are usually on the shelf, but if not, I get them bent up and out ASAP. Contact me first if you'd like to be sure I've got one ready.*